Conventional
Stamped Parts & Fabrications
Parts are made in machine or stamping presses by precision and traditional stamping methods, deforming (punching, blanking, cutting, bending, drawing, coining) sheet metal in powered presses.
-Any formable metal
-Precision parts, typical +/-.003
-Excellent surface finish
-Wide variety of shapes and sizes
-Short and long runs
-Rapid production rate
-Good uniformity
-No porosity
Gripflow Stamping Process-
Parts are stamped using special close tolerance dies producing stampings with smooth edge finish excellent flatness, very close linear tolerances.
-Close tolerances +/-.0005
-Flatness within .001 or within strip stock limits
-Holes as small 30% of material thickness
-Holes as close to the edge of material 30% of
material thickness
-Chamfers, 'semi-pierce', weld projections, coin,
draw, offsets, countersinks
-Smooth edges to 32RMS